Checkout us now open. Please read here before ordering.

Enclosure preparation

Remove the paint around the input and output XLRs mounting holes on the back panel.


Remove the paint from the inside edges of the cut-outs as well.

Solder chassis contact to pin 1 of both input and output XLRs.

Screw both XLRs to the back panel with just two screws (as shown on the photo).

If you ordered your enclosure with pre-installed threaded inserts, you can move on to the next step.


Otherwise you'll need to drill the holes yourself. We provide drill templates to make your life a bit easier.

4-channel frame system drill template, part 1 (left side)


4-channel frame system drill template, part 2 (right side)

We are ready for Wiring the module